Pipe bending machine is a new type of pipe bending tool with the function of bending pipe and lifting the top. It has many advantages such as reasonable structure, safe use, convenient operation, reasonable price, quick loading and unloading, easy to carry and multi-purpose. It occupies a large share in the domestic hydraulic pipe bending machine market, and is mainly used in factories, warehouses, wharves, buildings, railways, automobiles and other pipelines installation and repair. In addition to the function of bending pipe, it can also unload the bending pipe parts as a separate hydraulic lifting machine.
Then the purchased pipe bender should pay attention to the following points when using it:
1. Before operation, please check whether the lubricating points of the machine are short of oil, whether the safety protection device is reliable, whether the movement mechanism is loose, and wait for a confirmation to start the operation.
2. Start the oil pump of the bender to check whether the system pressure is kept within the specified range. If it is high, it will damage the hydraulic components and waste power.
3. Adjust the required position and Angle of the parts, and position the parts to the required length.
4, adjust the vertical lifting guide rail, so that the guide mold pressing cylinder forward can clamp tight iron pipe.
5. The clamping cylinder can clamp the iron pipe.
6. Normal operation will put the workpiece into the bending die, and the front end contact positioning, step down the foot switch, it can be completed.
7. After the work, cut off the power supply and do a good job of cleaning and lubrication.
8. In case of emergency when operating the pipe bender, press the emergency stop button, then turn the twist switch to the manual position, and reset manually. If there is a fault, please report it to repair in time.
Let's talk about the eight methods of pipe bender maintenance:
A: When operating the pipe bender, the operation must be carried out in strict accordance with the operating rules (key points).
Two: The bender must be kept clean, and the unpainted part should be coated with anti-rust grease.
Three: Add lubricating oil regularly, at fixed points and quantitatively according to the requirements of the lubrication chart before starting the bender each time, and the oil should be clean without precipitation.
Four: regularly check and repair switches, insurance, handle, to ensure their reliable work.
Five: the lubricating oil in the motor bearing should be replaced and replenished regularly, and the motor part should be checked regularly for normal operation.
Six: regularly check the triangle belt, handle, knob, button damage, serious wear should be replaced in time.
Seven: non-designated personnel is prohibited to operate the equipment, usually must be done to leave the machine stop.
Eight: Oil and clean the pipe bender 10 minutes before leaving work every day.
According to the last table and experts, in addition to the function of bending pipe, the bender can also be used as a separate hydraulic lifting machine by removing the cylinder in the bending pipe components. Generally use good anti - emulsifying performance, anti - foam performance. Oil with good lubrication properties.
